The design of our "dipping pins", the different defects and the out-flow of the capsules have always been a priority for our service R&D.

The design of our capsules has been completely reviewed two years ago. They have a pre-assembly with 8 points (8 pre-locks) which avoids the ovalisation for a better closing on the filling machines. Since January 2001, all our capsules also have a conical closing for a better running on your machines for filling on machines with high speed.

We invested 1,8 Millions € to continue to modernize our manufacturing machines  and for the vision. This plan follows an initial investment of 1,5 Millions € for the implementation of cameras to aim at "zero defect".
With our program of research, these are thus more of 4,6 Millions € that have been invested for three years to obtain one of the most effective production tool of the market.

We foresee the installation of 6 additional machines and also we intend to enlarge the factory. We continue our research for the construction of a new factory or the acquisition of another group.

We work also on the integration of stadard processes to dry with more efficiency, and the control by electronic vision of the capsules. This integration would enable us to avoid the different manipulations of our capsules and to seal the boxes just at the exit of the production machine.

A training plan exists also for everyone . It aims at offering everyone the same knowledge of the tools and the finally the flow of processes.

All these improvements are done with only one goal, to offer to our customers a good running on their machines and a product aiming the" 0 defect ".